TigerNet Wireless Configuration Instructions
for Faculty and Staff using Windows Vista
For information about using wireless access on campus at Fort Hays State University, click here.
Students should not use these instructions; they should choose the TigerNetStudent SSID and connect using their TigerTracks login.
Faculty and staff should follow the setup instructions below, and then use their FHSU network login to connect. If your network login does not allow access, you should submit a CTC Request for Services to the Network and Servers section (through Lotus Notes) to request wireless access.
Please note that wireless setup instructions can vary depending on the type of wireless card installed in your system. These steps will work for many types of cards installed on Windows Vista systems, but they may not match your setup. If these instructions do not work for you, or if you need assistance after attempting to configure your wireless connection, please contact the CTC HelpDesk to arrange a time for individual assistance.
Configuration Procedures:
In order to properly configure your connection, it is necessary to be in a location where a TigerNet signal is detected.
-
Click on the Wireless Network icon to view available networks.
-
Click Connect to a Network.
-
Select the TigerNet SSID and click Connect.
-
Click Enter/select additional log on information.
-
Type in your username and password and select OK.
-
When prompted to validate the certificate select OK.
-
After you are connected to TigerNet, place a checkmark in the box next to Save this network.
If you have problems…
Review these procedures and check to make sure you have followed all steps as instructed. If you need further assistance, visit the Fort Hays State University CTC HelpDesk or call us at (785) 628-5276 or 1-800-628-FHSU. Before calling for problem assistance, write down the steps you have done so far and any error messages you may have received. |
